Receiver: Ammonia, horizontal, 10-inch diameter x 10 feet long fusion welded, complete with inlet, outlet, drain, purge and dual relief valves, liquid level gage with guard and stand.. Coolers, Product, Bush Mfg. Co. Hartford Conn. Mod. # FL- 24-4M; BTU-50,000; CFM-4200; room temp-40° F; refrig. temp. 20° F coil model C-4-10-6-46 (steel) blower- #15 DIDW centrifugal bearing-Randall #400 std. billow block 1716-inch shaft; casing by Lindsay Structure: valve-ALCO TGX-2 expansion solenoid shut-off; motor Wagner Elec. Co. 1 HP, RPI-208V, 3 phase 60 cyc. 1725 RPM; starter- Cutler Hammer #9115-1132; finish (inside-bitumastic; out- side paint); thermostat mercoid DA 55-3, operating solenoid shut-off valve ammonia hand shut-off valve, strainer, com- plete by-pass with hand expansion valve and back pressure regulator
17 Coolers: Product, Bush Mfg. Co. Model FL-24-3M; BTU- 40,000; room temp.-40° F; refrig. temp. 20° F; coil model-C- 3-10-6-46 steel; blower-#.15 DIDW centrifugal; bearings- Randall #400 std. pillow block 1716-inch shaft, casing by Lindsay Structure; Valves-ALCO TGX-2 expansion solenoid shut-off; motor-Wagner Elec. Co. 1 HP, RPI, 208 V, 3 phase 60 cycle 1725 RPM; starter-Cutler Hammer #9115, H32; finish (Inside bitumastic outside paint); thermo- stat-mercoid Da 55-3 operating solenoid shut-off valve, strainer, complete by-pass with hand expansion valve & back pressure regulation.
Coolers: Product, Bush Mfg. Co. model FL 18-4L; BTU- 23,000; CFM-220; room temp-35° F; refrig. temp 20° F; coil model C4.9.6-36 steel; blower #12 DIDW centrifugal; bearings-Randall #200 std. pillow block, 1 inch shaft, w/o motors, valves ALCO TGX-1 solenoid shut-off; starter Cutler-Hammer 9103; finish (inside bitumastic, outside- paint); thermostat-mercoid, DA 55-3 operating solenoid shut-off valve, in complete by-pass which contains hand expansion valve and back pressure regulator. Coolers: Product, Bush Mfg. Co. Model FL-3L BTU-14650; room temp. 35° F; coil model C-4-7-6-36 steel; blower #12 DIDW centrifugal; bearings-Randall #200 std 1 inch shaft, valves ALCO TGX 1 solenoid shut-off; casing by Lindsay Structure motor-Wagner Elec. Co. 4 HP RA 220 V 1 phase 60 cycle, 1725 RPM; starter-Cutler-Hammer #9103; finish (inside bitumastic, outside paint) thermostat mercoid DA 55-3, operating in a complete by-pass, a solenoid shut-off valve this by-pass contains ammonia hand shut off valve, strainer, hand expansion valve and a back pressure regula- tion..
Piping: all necessary ammonia, required to interconnect parts of this system. The piping is constructed to the following specifications: liquid and discharge mains and all piping operating at 185 PSIG-extra heavy blk, st. pipe; suction mains-standard weight blk, steel pipe; valves and fittings 1 inch and smaller (ammonia) screwed type, larger than inch-4 bolt flanged ammonia design... System C-10° freezer room-Compressors, ammonia, Vilter Mfg. Co. 41⁄2 inch stroke, vertical-2 cylinder; ser. #680814 and 680813; 360 RPM; refrig.-51,500 BTU/hr at 10° F suction temp. #135 condenser press., V-belt drive. Motors: Ideal Elec. Co. 15 HP, 1740 RPM 3 phase, 60 cycle, 208 V; switches Allen Bradley Bull, 709 across the line starters and disconnect switches automatic contrcl by means of: 1 mercoid high pressure cut-out, 1 mercoid low pressure cut-out 1 high pressure gauge and 1 suction gauge (gauges-J. P. Marsh Co.) (Cost of gauge $63.00). Condenser, evap. (Ammonia) Acme Industries Co. model 275, capacity-152,500 BTU/hr temp. 78° F wet bulb 96° F condensing; operating pressure-185 PSIG; prime surface- steel pipe hot dip galv. CFM-3800; fan & pump moter Gen- eral Elec. 11⁄2 HP, 3 phase, 220/440V; switches-automatic starter & fused safety switch, mercoid pressure switches for high and low pressure cut-off.
Receiver, ammonia, horizontal, 8 inches x 10 feet 0 inches long, complete w/inlet, outlet, drain, purge, & dual relief valves, liquid level gauge w/guard and stand; gauge-2, J. P. Marsh 1 compound, 1 high pressure.
Units, Cooling, Vilter, Artic Co. Model ST-1000, CFM-5150; capacity at 5° F, 25,700 BTU/hr; room temp. 100° F, motor- 11⁄2 HP, 220/440V; 3 phase 60 cycle for fan and circulating pump; valves-ALCO thermostat expansion ALCO solenoid valves complete by-pass and shut-off valves, control-ther- mostatic, Ehite Rogers Electric..
INSTRUCTIONS AND CERTIFICATES See also AR 5-160
1. For every invitation for bids an abstract of bids form will be prepared as soon as practicable after the bids have been opened or as soon as it is decided to cancel the invitation before opening bids.
2. Every form will bear entries conforming to the following examples on page No. 1. If the entry in 3 below is made, the Opened entry will not be made. Invitation for bids No. "728-37-18." Total pages "6."
FOLD ALONG THIS LINE FOR FILING
ABSTRACT OF BIDS NO. "728-37-18"
Description of the items or the following entry: "See attached invitation."
*List on any page only the bumbers of those bids received for the items Included on that page.
6. If bids were opened and the awards are not to be made by the person who opened the bids he will sign the following in the space provided below: I CERTIFY that I have personally opened and read all bids received, verified all entries on this abstract extracted from those bids and find it correct.
7. When action on the bids has been completed, suitable entries showing such action will be made. The following are examples of possible entries for the items in the example of paragraph 5 above:
Item 1-Check .12 of bidder No. 1 in red; Item 2-Check 1.18 in red; Item 3-Check .29 in red, check .26 in blue, and add the following to the remarks: "Rejected for that reason because size specified is essential"; Item 5-Check the 24.13 which was determined by lot and under the item enter: "Award made as directed in AR 5-160"; Item 6-Under this item enter: "All bids received on this item have been rejected-Purchase will not be made"; Item 7-Check .735 in red, check .72 in blue and add the following to the remarks: "Award made as directed in AR 5-340."
8. When the abstract has been completed as indicated above and except when the invitation was canceled or when no bids were received, the person whose duty it is to make the awards will sign the following, deleting a if the certificate in 6 above has been signed, and distribute the abstract:
a. I have personally opened and read all bids received, verified all entries on this abstract extracted from those bids and find it correct.
b. I have made the awards or rejected the bids as indicated on this abstract.
This space to be filled in for reference
« iepriekšējāTurpināt » |