Laser Induced Damage in Optical Materials: Proceedings of a Symposium Sponsored by the American Society for Testing and Materials and by the National Bureau of StandardsU.S. Department of Commerce, National Bureau of Standards, 1989 |
No grāmatas satura
1.–5. rezultāts no 71.
viii. lappuse
... Fluence UV Light Exposure J. Early , V. Sanders , and W. Leamon Thermal Imaging Studies of Laser Irradiated Coated Optical Surfaces Alan F. Stewart , Adam Rusek , and Arthur H. Guenther Effect of n - on - 1 Laser Treatment on Damage ...
... Fluence UV Light Exposure J. Early , V. Sanders , and W. Leamon Thermal Imaging Studies of Laser Irradiated Coated Optical Surfaces Alan F. Stewart , Adam Rusek , and Arthur H. Guenther Effect of n - on - 1 Laser Treatment on Damage ...
62. lappuse
... fluence of the excimer laser is then increased until the damage threshold is reached , whereupon the surface is re - imaged . Computer aided analysis of the transient image allows the areas of anomalous absorption to be found , which ...
... fluence of the excimer laser is then increased until the damage threshold is reached , whereupon the surface is re - imaged . Computer aided analysis of the transient image allows the areas of anomalous absorption to be found , which ...
63. lappuse
... fluence on the target . Damage detection at Loughborough has been developed to a point where it is routinely performed by use of high resolution Schlieren imaging ( i.e. imaging with a suitable stop / filter in the focal plane of the ...
... fluence on the target . Damage detection at Loughborough has been developed to a point where it is routinely performed by use of high resolution Schlieren imaging ( i.e. imaging with a suitable stop / filter in the focal plane of the ...
64. lappuse
... fluence ( ≈10 % of the single shot damage threshold ) excimer pulses . Image b was obtained by firing the dye laser 375 ns after the excimer pulse so that the transient i.e. non - damaging heating of the sample could be recorded ...
... fluence ( ≈10 % of the single shot damage threshold ) excimer pulses . Image b was obtained by firing the dye laser 375 ns after the excimer pulse so that the transient i.e. non - damaging heating of the sample could be recorded ...
65. lappuse
... fluence i.e. furthest below the single shot damage threshold that would give a readily detectable signal . For the ... fluence of 0.18 J cm and the damage caused by a single excimer pulse of fluence 0.56 Jcm - 2 . Figures 2a - c show ...
... fluence i.e. furthest below the single shot damage threshold that would give a readily detectable signal . For the ... fluence of 0.18 J cm and the damage caused by a single excimer pulse of fluence 0.56 Jcm - 2 . Figures 2a - c show ...
Saturs
xiii | |
xix | |
xxxiv | |
12 | |
22 | |
34 | |
42 | |
48 | |
232 | |
245 | |
259 | |
265 | |
273 | |
286 | |
287 | |
311 | |
61 | |
74 | |
87 | |
98 | |
105 | |
118 | |
122 | |
128 | |
140 | |
152 | |
166 | |
175 | |
183 | |
189 | |
211 | |
212 | |
328 | |
348 | |
361 | |
377 | |
385 | |
398 | |
414 | |
427 | |
440 | |
455 | |
462 | |
470 | |
502 | |
516 | |
Citi izdevumi - Skatīt visu
Bieži izmantoti vārdi un frāzes
absorption Alamos approximately avalanche BaF2 band gap BDH sample Boulder Damage Symposium BRDF CaF2 calculated cerium chamfers coefficient crystal curve Damage in Optical damage testing damage threshold defects density dependence deposited detector diameter dielectric dye laser effect electron avalanche emission excimer excimer laser experimental F-center fluence fluoride fused silica glass Guenther heating imaging impurities incident increase intensity interface ionization irradiation J/cm² laser beam laser damage threshold Laser Induced Damage laser irradiation laser pulse laser-induced layer lens Livermore measured MgF2 mirror MOSFETs multiphoton Nd:YAG nonlinear observed optical coatings Optical Materials P.O. Box parameters particles peak photodiodes photon Phys polished poly-silicon pulse energy radiation reflectance reflectivity loss reflectors refractive index scan scatter shot shown in figure shows SiO2 slab spectra sputtering stress structure substrate surface technique temperature thickness thin films TiO2 transient values wavelength
Populāri fragmenti
iv. lappuse - Certain commercial equipment, instruments, or materials are identified in this paper in order to adequately specify the experimental procedure. Such identification does not imply recommendation or endorsement by the National Institute of Standards and Technology, nor does it imply that the materials or equipment identified are necessarily the best available for the purpose.
531. lappuse - Bureau on building materials, components, systems, and whole structures. The series presents research results, test methods, and performance criteria related to the structural and environmental functions and the durability and safety characteristics of building elements and systems. Technical Notes — Studies or reports which are complete in themselves but restrictive in their treatment of a subject. Analogous to monographs but not so comprehensive in scope or definitive in treatment of the subject...
531. lappuse - The Journal of Research of the National Bureau of Standards reports NBS research and development in those disciplines of the physical and engineering sciences in which the Bureau is active. These include physics, chemistry, engineering, mathematics, and computer sciences. Papers cover a broad range of subjects, with major emphasis on measurement methodology, and the basic technology underlying standardization. Also included from time to time are survey articles on topics closely related to the Bureau's...
531. lappuse - NIST under the sponsorship of other government agencies. Voluntary Product Standards -Developed under procedures published by the Department of Commerce in Part 10, Title 15, of the Code of Federal Regulations. The standards establish nationally recognized requirements for products, and provide all concerned interests with a basis for common understanding of the characteristics of the products.
531. lappuse - Handbooks — Recommended codes of engineering and industrial practice (including safety codes) developed in cooperation with interested industries, professional organizations, and regulatory bodies. Special Publications...
531. lappuse - NBS administers this program as a supplement to the activities of the private sector standardizing organizations. Consumer Information Series — Practical information, based on NBS research and experience, covering areas of interest to the consumer. Easily understandable language and illustrations provide useful background knowledge for shopping in today's technological marketplace.
332. lappuse - Laboratory is operated by Battelle Memorial Institute for the US Department of Energy under contract DE-AC0676RLO 1830.