MALFUNCTION Table 3-1. Troubleshooting. Continued TEST OR INSPECTION CORRECTIVE ACTION MWLD EQUIPMENT - Continued 4. NO ALARM ON MWLD TORSO HARNESS WHEN TESTED Step 1. Remove battery. Wait 10 seconds, reinsert battery and retest. Step 2. If still no alarm. Replace battery and retest. Step 3. If still no alarm. Report on DA Form 2404 and replace torso harness. 5. NO ALARM ON MWLD HELMET HARNESS WHEN TESTED Step 1. Check that bottom of harness overhangs entire rim of helmet. Retest. Step 2. If still no alarm. Remove and reinsert battery and retest. Step 3. If still no alarm. Place helmet on another soldier with operating torso harness and retest. Step 4. If still no alarm. Replace battery and retest. Step 5. If still no alarm. Report on DA Form 2404 and replace helmet harness. MALFUNCTION 6. 7. 8. 9. TEST OR INSPECTION CORRECTIVE ACTION MILES CONTROL CONSOLE CONTROL CONSOLE DISPLAY SHOWS A NUMBER OTHER THAN 00 OR IS BLANK DURING TESTING Step 1. Disconnect and reconnect cable connectors labeled control console or battery. Recheck for 00 by pressing control console display button. Step 2. If display is still blank. Ask controller to check out equipment using vehicle test set. CONTROL CONSOLE DISPLAY DOES NOT SHOW THE NUMBER 88 DURING TESTING Step 1. Turn console switch to HIT/KILL and back to SELF TEST. Check display. Step 2. If display still does not show 88. Ask controller to check out equipment using vehicle test system. CONTROL CONSOLE DISPLAY DOES NOT SHOW THE NUMBER 55 DURING TESTING Step 1. Ask controller to check out equipment using vehicle test set. CONTROL CONSOLE DISPLAY DOES NOT SHOW THE NUMBER 54 (FOR M1) OR 50 (FOR M1A1) DURING TESTING Step 1. Check all MILES trigger cable connections. Tighten any loose connections. Step 2. Fire the main gun. Check for number 54 or 50 on display. Step 3. If display still does not show 54 or 50. Ask controller to check out equipment using vehicle test set. 10. NO "KILL" INDICATION WHEN MAIN GUN FIRED AT MWLD TORSO HARNESS DURING TESTING Step 1. Check all MILES breech cable connections. Tighten any loose connections. Step 2. Fire the main gun when a detector on a man worn torso harness is held in front of the transmitter inside the turret. Check for "KILL" indication. Step 3. If still no "KILL" indication. Ask controller to check out the system using vehicle test set. 11. NO HIT INDICATION WHEN COAX MACHINE GUN FIRED AT A TARGET DURING TEST Step 1. Check coax microphone cable connections. Tighten any loose connections. Step 2. Fire coax machine gun at a target. Check for hit indication. Step 3. If still no indication. Ask controller to check out the equipment using vehicle test set. 12. NO INTERCOM TONE Step 1. Check vehicle intercom. Turn to ON. Step 2. Check vehicle intercom cable connections at intercom terminals. Tighten any loose connections. Step 3. If still no tone. Ask controller to check out the equipment using vehicle test set. |