Test Subtask 2-E: Belt Test. 77 2 1 Make sure MASTER VEHICLE POWER and UTILITY POWER switches are ON. Check that all cable connections to detector belt segments are tight. Ask a crewmate to check that CVKI cable connections to control console and utility connector are also tight. Ask controller to test your belt segments by setting his controller gun (1) on "NEAR MISS," and firing at each detector from a distance of 3 to 10 feet. Each time he fires the CVKI light (2) should flash. If the CVKI fails to flash for some or all of the detectors, go to Troubleshooting, page 3-6. NOTE It is OK for one detector on each belt segment to be bad. ALIGNMENT TASKS INDEX Page 1. Align M1 Main Gun (105 mm)/Coax MG Laser Transmitter 2-68 1.1. Align M1A1 Main Gun (120 mm)/Coax MG Laser Transmitter 2-74 2. Align M2 Machine Gun 2-74.4 Perform either task 1 or task 1.1 and task 2 in the order given. Align Task 1: Align M1 Main Gun (105 mm)/Coax MG Laser Transmitter. The MILES main gun/coax MG laser transmitter is aligned by completing the following subtasks: Align Subtask 1-A: Prepare for manual input Align Subtask 1-B: Manual data input NOTE Proper alignment is critical to operation of MILES system for M1 main gun and coax machine gun. Read all instructions for Align Task 1 before proceeding. Then carefully perform each step in the order given. Prior to aligning main gun and coax machine gun laser transmitter, be sure to check and adjust "normal mode drift" out of system |