Outside Task 12: Install CVKI Cable Assembly. Remove periscope window (1) from loader's hatch. Safely store window for later installation following training exercise. Leave hatch open. On the CVKI cable assembly (2) locate the two connectors labeled P2 DETECTOR BELT and P3 KILL INDICATOR. From inside the hatch, feed the two connectors through open periscope window to the outside. Continue feeding cable through periscope window until fastener pad attached to cable is positioned over fastener tape on the inside of hatch (3). Secure pad to tape. Climb outside turret and close loader's hatch (4). Attach both cables to handle on loader's hatch using cable tie that is attached to one of the cables (5). Locate cable labeled P2 DETECTOR BELT. Route cable around hinge and push it into space between armor plate and V-shaped metal assembly (6). Attach cable tie to mounting bracket (7). Secure cable to the two 12-inch fastener strips that are glued to turret (8). One pad is on the side and the other on top of turret. Route cable along side of turret (9). Connect plug labeled P2 DETECTOR BELT into the UPPER connector on the rear detector belt (10). Put plug under protective flap (11). Outside Task 12: Install CVKI Cable Assembly (Cont). 13 14 12 Return to loaders' hatch. Route cable labeled P3 KILL INDICATOR between hinge on loader's hatch and V-shaped metal assembly. Follow route shown (12). Attach cable ties to three mounting brackets as shown (13). Attach plug labeled P3 KILL INDICATOR to connector on rear of CVKI (14). |