Outside Subtask 6-B: Install Rear Belt Segment - Without Bustle (Cont).

Return to the electronics box and working to your right, begin attaching detector belt to fastener tape. Place a wedge block (8) behind each detector in the same manner they were installed on left side.

When you reach right corner of the turret, jump to the end of the belt. Attach connector to fastener tape on right side of turret beginning at a point about in the center of the two rear vertical railing supports and work toward rear (9). Do not force belt between tow cable bracket and bustle rack bracket. If space is very narrow insert only belt edge between brackets.

You should now have about 24 inches of excess belt material. Press excess material together to make a 12-inch length (10).

Place folded material over lower railing and behind vertical railing support. Tie it to lower railing using the fastener tie attached to the belt (11). Readjust belt on fastener tape as required to make a secure installation.

Locate one of detector belt segments labeled No. 3 and two wedge blocks.

Starting in RIGHT REAR CORNER of turret, place the connector next to connector from the rear belt (1).

Work toward your right and press the detector belt firmly against the fastener tape (2).

Place a wedge block (3) behind last two detectors. Install wedge blocks with red side OUT (facing you) and pointed end DOWN.

Right end (4) of belt should end up approximately 5 inches from main gun.

Connect the side belt and rear belt connectors. Cover with protective flap (5).

Outside Task 9: Inspect and Service CVKI Assembly.

2

Inspect CVKI assembly (1) for any damage that would affect proper installation or operation. Inspect yellow lens (2) for cracks.

Report any damage on DA Form 2404. Replace only if lens is cracked or if unit is not operable.

Outside Task 10: Install CVKI Assembly.

Using adjustable or socket wrench, remove two bolts (1) from the top left corner of turret. There are four bolts in that area but only the two shown have to be removed.

Set CVKI assembly (2) over bolt holes. Connector on CVKI must face the rear.

Replace the original bolts (3) and tighten securely with wrench.