Log Data Acquisition and...Editions OPHRYS, 1991 - 330 lappuses |
No grāmatas satura
1.5. rezultāts no 62.
3. lappuse
... instance [ 12 ] . A general bibliography is located at the end of the book . These fundamental documents are denoted by Roman numerals , for instance [ XVII ] . 1.2 Changes in the nineties At the start of the V.
... instance [ 12 ] . A general bibliography is located at the end of the book . These fundamental documents are denoted by Roman numerals , for instance [ XVII ] . 1.2 Changes in the nineties At the start of the V.
11. lappuse
... instance , a salt dome or the casing of a blowout well as seen from a relief well [ 12 and 23 ] . The maximum depth of investigation of this survey is 500 m ( 1600 ft ) and the resolution of the device is poor , from 100 m ( 330 ft ) to ...
... instance , a salt dome or the casing of a blowout well as seen from a relief well [ 12 and 23 ] . The maximum depth of investigation of this survey is 500 m ( 1600 ft ) and the resolution of the device is poor , from 100 m ( 330 ft ) to ...
12. lappuse
... instance , faults or massive heterogeneities ) and characterize them . The a priori evaluation of the radius of investigation provides a guide on test duration and also on the successive sequences of flows and shut - ins . 3260 Borehole ...
... instance , faults or massive heterogeneities ) and characterize them . The a priori evaluation of the radius of investigation provides a guide on test duration and also on the successive sequences of flows and shut - ins . 3260 Borehole ...
19. lappuse
... instance , in gross terms , it could be said that in a given geological province , sand channels have width , height , and length linked [ 2 ] by Length = a x Width = b x Height , where a and b are constant . This relation is depicted ...
... instance , in gross terms , it could be said that in a given geological province , sand channels have width , height , and length linked [ 2 ] by Length = a x Width = b x Height , where a and b are constant . This relation is depicted ...
21. lappuse
... instance , core and log information are often compared , yet both are subject to a number of uncertainties . Forcing one data set to fit the other exactly may lead to incorrect evaluation of the formation . References 1 Albright , J. N. ...
... instance , core and log information are often compared , yet both are subject to a number of uncertainties . Forcing one data set to fit the other exactly may lead to incorrect evaluation of the formation . References 1 Albright , J. N. ...
Saturs
LXXXII | 220 |
LXXXIII | 227 |
LXXXV | 228 |
LXXXVI | 233 |
LXXXVIII | 234 |
LXXXIX | 236 |
XC | 238 |
XCI | 242 |
23 | |
24 | |
25 | |
28 | |
33 | |
36 | |
37 | |
42 | |
45 | |
46 | |
47 | |
48 | |
56 | |
61 | |
XXVIII | 69 |
XXIX | 71 |
XXX | 73 |
XXXI | 75 |
XXXII | 76 |
XXXIV | 77 |
XXXV | 79 |
XXXVII | 81 |
XXXVIII | 83 |
XXXIX | 87 |
XL | 90 |
XLI | 95 |
XLII | 99 |
XLIII | 101 |
XLIV | 103 |
XLV | 107 |
XLVI | 109 |
XLVII | 113 |
XLVIII | 117 |
XLIX | 120 |
L | 124 |
LI | 130 |
LII | 133 |
LIII | 134 |
LIV | 135 |
LV | 139 |
LVI | 140 |
LVII | 142 |
LVIII | 144 |
LIX | 147 |
LXII | 151 |
LXIII | 153 |
LXIV | 159 |
LXV | 160 |
LXVI | 161 |
LXVII | 164 |
LXVIII | 167 |
LXIX | 175 |
LXX | 176 |
LXXI | 177 |
LXXII | 180 |
LXXIII | 186 |
LXXIV | 190 |
LXXV | 191 |
LXXVI | 192 |
LXXVII | 199 |
LXXVIII | 203 |
LXXIX | 211 |
LXXX | 212 |
LXXXI | 217 |
XCII | 248 |
XCIII | 259 |
XCIV | 262 |
XCV | 269 |
XCVI | 273 |
XCVII | 274 |
XCVIII | 275 |
XCIX | 277 |
C | 286 |
CI | 292 |
CII | 293 |
CIII | 294 |
CIV | 297 |
CV | 299 |
CVI | 301 |
CVII | 304 |
CVIII | 307 |
CIX | 309 |
CX | 310 |
CXI | 314 |
CXII | 321 |
CXIII | 325 |
CXIV | 326 |
CXV | 330 |
CXVI | 331 |
CXVIII | 333 |
CXIX | 334 |
CXX | 337 |
CXXI | 339 |
CXXII | 340 |
CXXIII | 343 |
CXXIV | 344 |
CXXV | 346 |
CXXVI | 348 |
CXXVII | 349 |
CXXVIII | 353 |
CXXX | 359 |
CXXXI | 361 |
CXXXII | 362 |
CXXXIII | 364 |
CXXXIV | 373 |
CXXXV | 374 |
CXXXVI | 375 |
CXXXVII | 376 |
CXXXVIII | 380 |
CXXXIX | 385 |
CXL | 386 |
CXLI | 394 |
CXLII | 395 |
CXLIII | 398 |
CXLIV | 407 |
CXLV | 413 |
CXLVII | 416 |
CXLVIII | 420 |
CXLIX | 423 |
CL | 428 |
CLII | 431 |
CLIII | 433 |
CLIV | 437 |
CLV | 439 |
CLVI | 447 |
CLVII | 449 |
Citi izdevumi - Skatīt visu
Bieži izmantoti vārdi un frāzes
accuracy acquisition Anadrill analysis annual logging symposium axis barite borehole cable calibration caliper characteristics computed core corresponds counting rates Courtesy of Schlumberger Courtesy of SPWLA curves data quality defined density logging depth matching depth of investigation derived detector device diameter downhole drilling effect environment environmental corrections example filtering fluid formation evaluation ft/h g/cm³ gamma ray geometrical factor Halliburton Logging Services hole input interval invasion laterolog Log Analyst log quality control logging company logging data logging speed logging tool measurement METER method mmho/m modeling mudcake neutron porosity nonconformities ohm-m oil-base mud parameters performed petrophysical precision pressure reference reservoir resistivity sampling rate seismic sensors signal sonde error sonic standard deviation standoff surface systematic error TABLE temperature thermal neutron tool response Trans uncertainty vertical resolution volume water saturation wellsite wireline logging zone
Populāri fragmenti
233. lappuse - RM is defined as a material or substance one or more properties of which are sufficiently well established to be used for the calibration of an apparatus, the assessment of a measurement method, or for assigning values to materials.
46. lappuse - Parameter, associated with the result of a measurement, that characterizes the dispersion of the values that could reasonably be attributed to the measurand.
434. lappuse - ... for practical purposes, the value towards which the average of single results obtained by N laboratories tends, when N becomes very large (Note 5). Consequently, such a true value is associated with the particular method of test employed.
233. lappuse - Set of operations that establish, under specified conditions, the relationship between values of quantities indicated by a measuring instrument or measuring system, or values represented by a material measure or a reference material, and the corresponding values realized by standards.
233. lappuse - The set of operations which establish, under specified conditions, the relationship between values indicated by a measuring instrument or measuring system, or values represented by a material measure, and the corresponding known values of a reference standard.
343. lappuse - I have made this letter longer than usual, only because I have not had the time to make it shorter.
26. lappuse - ... Planning and Statement of Objectives USEPA has spent considerable effort in developing planning guidance, known as Data Quality Objectives (DQO's) which can be applicable to site assessment planning.(USEPA "Guidance for Data Quality Objective Process," QA/G-4(USEPA, 2000c). This process includes seven steps. - State the problem -Identify the decision -Identify inputs to the decision -Define study boundary areas -Develop a decision rule -Specify decision error limits -Optimize design for obtaining...
107. lappuse - The becquerel is the activity of a radionuclide decaying at the rate of one spontaneous nuclear transition per second. The degree Celsius is equal to the kelvin and is used in place of the kelvin for expressing Celsius temperature (symbol t) defined by the equation / = T - T0 where T is the thermodynamic temperature and T0 = 273.15 K.
Atsauces uz šo grāmatu
Statistical Regression Line-Fitting in the Oil and Gas Industry Richard Woodhouse Priekšskatījums nav pieejams - 2003 |