Laser Induced Damage in Optical Materials: Proceedings of a Symposium Sponsored by the American Society for Testing and Materials and by the National Bureau of StandardsU.S. Department of Commerce, National Bureau of Standards, 1988 |
Saturs
| 8 | |
| 11 | |
| 33 | |
| 44 | |
| 61 | |
| 80 | |
| 101 | |
| 120 | |
| 299 | |
| 305 | |
| 319 | |
| 333 | |
| 350 | |
| 374 | |
| 388 | |
| 403 | |
| 127 | |
| 138 | |
| 146 | |
| 152 | |
| 159 | |
| 170 | |
| 182 | |
| 203 | |
| 215 | |
| 227 | |
| 236 | |
| 248 | |
| 261 | |
| 270 | |
| 282 | |
| 412 | |
| 419 | |
| 429 | |
| 438 | |
| 449 | |
| 460 | |
| 472 | |
| 480 | |
| 486 | |
| 497 | |
| 515 | |
| 529 | |
| 547 | |
Citi izdevumi - Skatīt visu
Bieži izmantoti vārdi un frāzes
absorption anatase angle of incidence Appl beam profile breakdown bulk centers chopper CO2 laser crystal curve damage tests defects deposition desorption detector diameter dielectric effect electron electron beam evaporated emission energy density equation experimental fluence frequency function fused silica gallium arsenide Gaussian Gaussian beam glass inclusions interface ion assist ionization irradiation J/cm² laser beam laser damage threshold Laser Induced Damage laser pulse laser-induced layer linear Manuscript received measured metal microns Mo mirror Nd:YAG observed obtained optical coatings optical damage Optical Materials output oxide P.O. Box particles photon Phys pixels platinum polarizer polished Q-switched radiation Raman reflectance refractive index region sample scan scatter shot shown in figure shows signal silica silicon spatial spectra spectrum sputter deposition substrate surface damage surface roughness technique temperature thermal thickness thin film TiO2 values vidicon wavelength width yttrium oxide ZnS film ZrO2
Populāri fragmenti
560. lappuse - Laboratory for Laser Energetics UNIVERSITY OF ROCHESTER 250 East River Road Rochester, NY 14623-1299...
iv. lappuse - Certain commercial equipment, instruments or materials are identified in this paper in order to adequately specify the experimental procedure. In no case does such identification imply recommendation or endorsement by the National Bureau of Standards, nor does it imply that the material or equipment identified is necessarily the best available for the purpose.
11. lappuse - ... not infringe privately owned rights. Reference herein to any specific commercial products, process, or service by trade name, trademark, manufacturer, or otherwise, does not necessarily constitute or imply its endorsement, recommendation, or favoring by the United States Government or the University of California. The views and opinions of authors expressed herein do not necessarily state or reflect those of the United States Government thereof, and shall not be used for advertising or product...
539. lappuse - This work has been supported by the Procurement Executive, Ministry of Defence (Directorate of Components, Valves and Devices) and sponsored from the RSRE Establishment.
301. lappuse - DE-FC08-85DP40200 and by the Laser Fusion Feasibility Project at the Laboratory for Laser Energetics which has the following sponsors: Empire State Electric Energy Research Corporation, New York State Energy Research and Development Authority, Ontario Hydro, and the University of Rochester.